Can all cut sheet labels
be used in a laser printer?
No, some materials are not laser compatible. If your product is
going to run through a laser printer, please advise our customer
service staff at the time of quoting. Laser printers require materials
with special adhesives and laser compatible inks. It is important
to know the specific model of laser printer to assure the most
compatible stock(s) are chosen.
What causes label stock to
curl after coming out of the laser printer?
Laser printers use a combination of heat and pressure to fuse
the toner to the page; this process can drive moisture out of
the face stock and cause curling. In most cases the sheets will
naturally relax after a short time. If the sheets do not return
to normal or the material is curled before being imaged there
may be a problem with the material and/or storage conditions.
How important is grain direction
on laser cut sheet labels?
While it has been a generally accepted practice to run all paper
cut sheets long grain, ANSI standards do not specify grain directions
on materials over 24#. Heavier materials such as labels with a
heavy liner may actually run better short grain due to the added
flexibility. Testing samples of the recommended material before
producing an order is suggested. We have materials that have been
tested in almost all of the popular desktop and high-speed printers
available.
Should the matrix be removed
around the outer edge of a cut sheet label for laser printers?
While this is a requirement on all cut sheet labels with a film
face stock, there is no standard procedure on paper face stocks.
In most cases, removing a 1/16" border from around the label
is a good idea to lessen the chance of adhesive ooze. However,
some printer manufacturers specify that no matrix be removed.
When in doubt, consult the owner's manual for the printer.
Are laser cut sheets always
wrapped?
Yes, we always shrink-wrap or poly-bag laser cut sheets in order
to minimize any problems caused by improper storage conditions.
Please note: exposure to high humidity conditions can cause
premature curling of the laser sheets.
Can cut sheet labels be floodcoated?
In general, it is better to run a screen plate than to floodcoat
laser labels. Full coverage of ink or even heavy ink areas can
cause curl during the laser printing process. A test run is a
good idea if heavy ink coverage is requested.
Can all materials be converted
into cut sheet labels?
No, some materials do not lay flat after being sheeted. Be sure
to consult your customer service representative if the material
being used has a lightweight liner or a film face stock.
